Crafts wood veneer

FOR CRAFT AND GIFT MAKERS

Thin wood veneer for crafts, and how we help you choose

Thin Veneer for Crafts

Marquetry · thin wood sheet · sliced figures · decorative craft · Natural / Engineered / Dyed veneer · Export specification

Home / Veneer Library / Crafts

What we can do for Crafts

CAPABILITY

Zhanhai produces veneer from log to sliced sheet, so the species, figure and specification you need can be scheduled against your own production line. Standard categories are held in stock; dyed and special figures are confirmed per order. Moisture content and colour difference are managed by piece, so a run reads consistently.

    Marquetry and inlayThin wood sheetsSliced wood figuresBox and gift packagingDecorative craft

Figures shown are typical ranges. Final supply is confirmed against the order specification and approved sample.

Key specification

SPECIFICATION
Typical thickness0.15 mm / 0.2 mm / 0.3 mm / 0.5 mm
Sheet size2500 × 1250 mm; smaller formats on request
Figure optionsStraight, crown, burl, ball, fiddleback
ColourNatural, dyed and smoked options
PackingPressed between plates or rolled, per customer line

Species available for Crafts

SPECIES RANGE

The species below are the ones most often specified for Crafts work. Actual supply follows the order specification and sample approval — we will advise on the suitable choice based on your substrate, downstream process and end use.

SpeciesCategoryAvailable figuresOrigin
Red Oak
3 specifications
天然木皮山纹 / 直纹北美洲
Ziricote
1 specifications
天然木皮直纹北美洲
Cherry(European)
1 specifications
天然木皮—欧洲
European Oak
8 specifications
天然木皮山纹 / 直纹欧洲
Chenchen
2 specifications
天然木皮球纹 / 直纹非洲
Berlinia
1 specifications
天然木皮直纹非洲
Claro Walnut
2 specifications
天然木皮山纹 / 直纹北美洲

Full catalogue with tone, figure and specification references: Open the veneer library

Vehicle parts in production

REAL COMPONENTS

Veneer interior components cut and finished for series production, photographed at the factory. Each part shows the figure match and edge finish that go into a vehicle programme.

Other industries

OTHER INDUSTRIES

Selection priorities differ by industry. Check the corresponding species and specification guidance.

Frequently asked questions

FAQ
What veneer thickness is best for marquetry?
For marquetry and inlay, 0.15–0.3 mm veneer is the usual range because it cuts cleanly and follows the pattern without chipping. Thicker veneer suits sliced figures and layered craft work.
Do you supply burl, crown and fiddleback figures?
Yes. Crown, burl, ball, fiddleback and other figure types are available on selected species. Figure availability is batch-dependent and confirmed with the quotation and sample.
Can craft veneer be dyed to custom colours?
Yes, dyed veneer is available for craft work, including single-colour and gradient effects on suitable species. Colour feasibility and fastness are confirmed against the reference sample.
Do you supply small quantities for craft makers?
Yes, we supply craft makers with smaller quantities from stock species, and can arrange pressed or rolled packing to suit hand-processing or automated cutting lines.

Tell us your species, thickness and volume

Our sales and engineering teams will review the feasible species and figure options, then provide samples, specification sheets and a quotation.

Request selection advice and quotation