Panel wood veneer

FOR PANEL MANUFACTURERS

Decorative veneer for panel makers, and how we help you choose

Decorative Veneer for Panel Makers

Laminated panels · decorative boards · UV real-wood panels · Natural / Engineered / Dyed veneer · Export specification

Home / Veneer Library / Panel

What we can do for Panel

CAPABILITY

Zhanhai produces veneer from log to sliced sheet, so the species, figure and specification you need can be scheduled against your own production line. Standard categories are held in stock; dyed and special figures are confirmed per order. Moisture content and colour difference are managed by piece, so a run reads consistently.

    Laminated panelsDecorative boardsUV real-wood panelsFurniture boardsDoor skins

Figures shown are typical ranges. Final supply is confirmed against the order specification and approved sample.

Key specification

SPECIFICATION
Typical thickness0.3 mm / 0.5 mm / 0.6 mm / 0.8 mm
Sheet size2440 × 1220 mm / 2500 × 1250 mm
Face optionsRaw, sanded, UV lacquered or melamine-faced
Core compatibilityMDF, particle board, plywood, aluminium composite
Supply formSheets, coils (for continuous lines) or cut-to-size

Species available for Panel

SPECIES RANGE

The species below are the ones most often specified for Panel work. Actual supply follows the order specification and sample approval — we will advise on the suitable choice based on your substrate, downstream process and end use.

SpeciesCategoryAvailable figuresOrigin
Red Oak
3 specifications
天然木皮山纹 / 直纹北美洲
Hard Maple
2 specifications
天然木皮直纹 / 山纹北美洲
Sweet Birch
1 specifications
天然木皮—北美洲
Basswood
1 specifications
天然木皮山纹北美洲
European Beech
1 specifications
天然木皮直纹欧洲
European Oak
8 specifications
天然木皮山纹 / 直纹欧洲
Ash
2 specifications
天然木皮乱纹 / 直纹北美洲

Full catalogue with tone, figure and specification references: Open the veneer library

Vehicle parts in production

REAL COMPONENTS

Veneer interior components cut and finished for series production, photographed at the factory. Each part shows the figure match and edge finish that go into a vehicle programme.

Other industries

OTHER INDUSTRIES

Selection priorities differ by industry. Check the corresponding species and specification guidance.

Frequently asked questions

FAQ
Can you supply veneer on coils for continuous panel lines?
Yes. For continuous laminating lines we can supply veneer in coils as well as sheets. Coil supply depends on species, thickness and backer, and is quoted separately.
Which veneer suits UV real-wood panels?
For UV-coated panels we typically recommend 0.3–0.5 mm veneer with a sanded surface and good porosity control. The grade is agreed against a UV-coated sample so the finish reads consistently.
Do you supply melamine-faced decorative veneer?
Yes, melamine-faced veneer is available for panel applications where the printed or solid-colour face is part of the product specification.
How is panel veneer matched for large orders?
Matching is defined by tone band and grain continuity across a run. For projects where a continuous surface matters, we sort to a narrower band and confirm against the reference sample.

Tell us your species, thickness and volume

Our sales and engineering teams will review the feasible species and figure options, then provide samples, specification sheets and a quotation.

Request selection advice and quotation