
FOR FLOORING MANUFACTURERS
Wood Veneer for Flooring
Zhanhai produces veneer from log to sliced sheet, so the species, figure and specification you need can be scheduled against your own production line. Standard categories are held in stock; dyed and special figures are confirmed per order. Moisture content and colour difference are managed by piece, so a run reads consistently.
Figures shown are typical ranges. Final supply is confirmed against the order specification and approved sample.
| Typical thickness | 0.6 mm / 1.0 mm / 2.0 mm |
|---|---|
| Sheet size | 2500 × 1250 mm |
| Wear layer options | Sliced or rotary cut, matched or random |
| Colour consistency | Batch-controlled; tone variation agreed in advance |
| Surface | Raw, brushed or sanded to customer grade |
The species below are the ones most often specified for Flooring work. Actual supply follows the order specification and sample approval — we will advise on the suitable choice based on your substrate, downstream process and end use.
| Species | Category | Available figures | Origin |
|---|---|---|---|
| Red Oak 3 specifications | 天然木皮 | 山纹 / 直纹 | 北美洲 |
| Eucalyptus 2 specifications | 天然木皮 | 直纹 | 大洋洲 |
| Hickory 1 specifications | 天然木皮 | 直纹 | 北美洲 |
| Hard Maple 2 specifications | 天然木皮 | 直纹 / 山纹 | 北美洲 |
| Teak 3 specifications | 天然木皮 | 直纹 | 亚洲 |
| European Oak 7 specifications | 天然木皮 | 山纹 / 直纹 | 欧洲 |
Full catalogue with tone, figure and specification references: Open the veneer library
Veneer interior components cut and finished for series production, photographed at the factory. Each part shows the figure match and edge finish that go into a vehicle programme.
Selection priorities differ by industry. Check the corresponding species and specification guidance.
Cabinet doors · table tops · headboards · chair backs
View optionsLaminated panels · decorative boards · UV real-wood panels
View optionsDashboards · door panels · trim · ambient light surrounds
View optionsMarquetry · thin wood sheet · sliced figures · decorative craft
View optionsOur sales and engineering teams will review the feasible species and figure options, then provide samples, specification sheets and a quotation.